Equipment we service
- Truck-mounted hard drive shredders used for on-site destruction
- Plant and stand-alone media shredders for hard drives, SSDs, tapes and phones
- Feed hoppers, chutes, guards and interlocks
- Motors, gearboxes, hydraulic drives and electrical controls
Common problems
| Problem | What we look at |
|---|---|
| Drives jam or bounce on top of the cutters | Cutter wear or chipping, feed design, drive torque |
| Fragments larger than they should be | Cutter and screen condition, spacing; especially important for SSDs, which need much smaller particles than spinning drives |
| Machine trips or stops mid-batch | Overload settings, motor and gearbox condition, sensors and interlocks |
| Noise, vibration or heat | Bearings, gearbox, shaft alignment |
Hard drive cutters take a beating: drive housings, platters and screws are far tougher than paper. Regular inspection catches chipped cutters before they damage shafts and bearings.
Media shredder down before a job?