
What a cutting chamber rebuild covers
Most mobile and plant paper shredders use rotary shear cutters: stacks of cutter discs and spacers on two or more shafts that turn toward each other. Strippers (combs) clean material off the cutters, and on many machines a screen controls the final particle size.
- Inspection and measurement of cutter wear, chipping and spacing
- Cutter and spacer replacement, or re-facing where that makes sense
- Stripper / comb replacement and adjustment
- Shaft, bearing and seal replacement
- Gearbox and drive checks
- Screen inspection and replacement for particle size
- Reassembly, timing and test run on real material
Signs your cutters are worn
| Sign | Why it matters |
|---|---|
| Larger or stringy particles | May no longer meet the particle size your certification or customer contracts require |
| More jams and auto-reverses | Lost time on every stop, and extra strain on the drive |
| Higher hydraulic pressure or motor load for the same work | Dull cutters make the whole system work harder and run hotter |
| Paper wrapping around the shafts | Often a stripper or spacing problem as well as wear |
| New knocking, grinding or vibration | Possible bearing, shaft or chipped-cutter damage — stop and check before it spreads |
Repair, rebuild or replace?
Not every worn chamber needs a full rebuild. Cam measures what is there and explains the options — from replacing a few damaged cutters, to a full rebuild, to replacing the chamber — with the trade-off in cost and downtime for each.
We work on the major mobile and plant shredding platforms, including Shred-Tech®, Alpine Shredders®, Allegheny® and Vecoplan® equipment, and more.
Particle size creeping up, or jams getting worse?