Home › Articles › Hydraulic Oil Running Hot

Article · Hydraulics

Why Shred Truck Hydraulic Oil Runs Hot

Hot oil is one of the most common shred truck complaints, especially in summer and on long route days. It is also one of the most expensive to ignore: heat breaks the oil down, hardens seals and wears out pumps.

Why heat matters

Every hydraulic system turns some of its power into heat. The cooler and reservoir are sized to get rid of that heat. When the system makes more heat than it can shed, the temperature climbs. Hot oil gets thinner, leaks past seals and internal clearances more easily, and wears parts faster — which makes even more heat. That is why overheating tends to get worse, not better.

The usual causes

CauseWhat to look for
Clogged coolerPaper dust and fibers packed into the cooler fins. Very common on shred trucks.
Cooler fan not runningFan, fan motor, relay, fuse or temperature switch fault.
Low oil levelLess oil means less time in the reservoir to cool. Look for leaks.
Restricted filtersOverdue filters, or a filter indicator showing bypass.
Internal leakageA worn pump, motor or valve lets oil slip back inside, turning power into heat instead of work.
Relief valve problemsA valve set wrong or stuck partly open sends oil over relief, which creates heat.
Wrong oilOil that is the wrong grade for the system or the season.
Dull cuttersWorn cutters make the shredder work harder for the same paper.

What drivers and mechanics can check

  1. Check the oil level with the system cold, and look for leaks around the pump, valves and hoses.
  2. Look at the cooler. If you cannot see light through the fins, it needs cleaning (follow your truck's manual).
  3. With the system running, confirm the cooler fan comes on.
  4. Check the filter indicators and the date of the last filter change.
  5. Note when it gets hot: right away, after a few hours, only in hot weather, or only when shredding heavy loads. That pattern points to the cause.

When to call for repair

If the cooler is clean, the fan works, the oil and filters are good and it still runs hot, the cause is likely inside a component — a worn pump or motor, or a relief valve problem. That takes pressure and flow testing to find. Running hot until something fails usually turns a component repair into a bigger one. CMB tests hydraulic systems on site; see hydraulic & PTO repair.

General information only. Always follow your equipment manufacturer's procedures and safety instructions.

Call (919) 586-1911 Request Service